Went to Fusion Garage to paste their huge logo onto their office wall.
We took almost an hour to decide where to place the logo, as the initial artwork, which was done by an interior artist did not include the pipe which is on the top left corner. So we discussed with the owner, shifted a few times, and finally decided to place it in the center of the wall, instead on extreme left.
The logo is 2.2m by 3m. We had to break it into segments as there’s no plotter and sticker this big… Then at the site, we arrange them in sequence and fix it on like a jigsaw puzzle. After the top piece is settled, the rest is lining them up… therefore the top piece cannot go wrong.
End product doesn’t look like it’s in segments, as matte has it’s natural way of hiding joint lines. It even look it’s painted on, as the sticker is even thinner than paper.